Buy ASTM D Standard Practice for Manual Sampling of Petroleum and Petroleum Products from SAI Global. Designation: D − Manual of Petroleum Measurement Standards (MPMS) , Chapter Standard Practice for. Manual Sampling of Petroleum and. This standard is issued under the fixed designation D ; the number immediately following This method was issued as a joint ASTM-API standard in
|Published (Last):||2 January 2011|
|PDF File Size:||15.58 Mb|
|ePub File Size:||5.4 Mb|
|Price:||Free* [*Free Regsitration Required]|
The practice does not cover sampling of electrical insulating oils and hydraulic fluids.
The procedures described in this practice are also applicable to sampling liquefied petroleum gases and chemicals. Link to Active 4d057 link will always route to the current Active version of the standard.
Active view current version of standard. Referenced Documents purchase d44057 The documents listed below are referenced within the subject standard but are not provided as part of the standard. USC units are reflected in parentheses.
Also, refer to Practice E Note 3 The procedure for special fuel samples for trace metal analysis is described in an appendix to Qstm D Practice D provides guidance on sample containers and preparation for sampling aviation fuel. Note 2 – The procedure for sampling liquefied petroleum gases is described in Practice D ; the procedure for sampling fluid power hydraulic fluids is covered in ANSI B Historical Version s – view previous versions of standard Translated Version s: Note 1 – The procedures described in this practice may also be applicable in sampling most noncorrosive liquid industrial chemicals, provided that all safety precautions specific to these chemicals are strictly followed.
Historical Version s – view previous versions of standard. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the aztm.
Seta Sampling Tube for ASTM D, ASTM D, IP 51
The procedure for sampling bituminous materials is described in Practice D Link to Active This link will always route to the current Active version of the standard. In the case of running or all-level samples, the sample only represents the column of material from which it was taken.
Active view current version of standard Translated Standard: ICS Number Code Procedures are also included for the sampling of free water and other heavy components associated with petroleum and petroleum products. As examples, a spot sample provides a sample from only one particular point in the tank, vessel compartment, or pipeline.
Also refer to Practices D and D These properties may be used for: A summary of the manual sampling procedures and their applications is presented in Table 1. ICS Number Code The procedure for special fuel samples for trace metal analysis is described in an appendix to Specification D It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.